Honda CBR650F Service Manual page 288

dummyhead dummyhead
– Throttle
handlebar [2])
INSTALLATION (CB650F/FA)
Apply grease to the cable groove and roll-up area of the
throttle grip [1].
Install the throttle grip/housing assembly onto the
handlebar [2].
Install the handlebar [1] and holder [2]. Tighten the front
Align the punch
bolts [3] first, then tighten the rear bolts [4] to the
mark with the edge
specified torque.
of the top bridge.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the rear throttle housing [1] by aligning the
locating pin with the hole in the handlebar.
Tighten the upper screw [2] first, then tighten the lower
screw [3] securely.
grip/housing assembly [1]
FRONT WHEEL/SUSPENSION/STEERING
(from the
[2]
[2]
[2]
[1]
[4]
[1]
[1]
[1]
[3]
Align
[2]
Align
16-11
[3]