Honda CBR650F Service Manual page 228

dummyhead dummyhead
Remove the snap ring [1] and one-way clutch [2].
INSPECTION
Inspect the following parts for scratch, damage,
abnormal wear and deformation.
– Starter driven gear
– Starter reduction gear
– Starter clutch outer
– Starter one-way clutch
Measure each part according to CLUTCH/GEARSHIFT
LINKAGE/STARTER CLUTCH SPECIFICATIONS
(page 1-8).
Replace any part if it is out of service limit.
ASSEMBLY
STARTER DRIVEN GEAR
NEEDLE BEARING
Apply engine oil to the one-way clutch [1] contacting
surface.
Install the one-way clutch into the starter clutch outer [2]
with its arrow mark [3] facing out.
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
SNAP RING
[2]
ONE-WAY CLUTCH
STARTER CLUTCH OUTER
[3]
[1]
[2]
[1]
WASHER
83 N·m (8.5 kgf·m, 61 lbf·ft)
11-15