Rear Brake - Honda CBR650F Service Manual

dummyhead dummyhead

REAR BRAKE

Support the motorcycle upright position on a level
surface and check the rear brake fluid level.
If the level is near the "LOWER" level line [1], fill the
brake fluid as follows.
Loosen the reservoir stay bolt [1].
Slightly pull the reservoir [2] upward and turn it
counterclockwise.
Align the groove with the tab, then temporarily tighten
the reservoir stay bolt.
Remove the following:
Take care not to
spill the fluid out of
– Two screws [3]
the reservoir.
– Reservoir cap [4]
– Set plate [5]
– Diaphragm [6]
Fill the reservoir with DOT 4 brake fluid from a sealed
container to the upper level line [7].
Install the diaphragm, set plate, reservoir cap and
tighten the screws to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
Loosen the reservoir stay bolt [1] and set the reservoir
[2] in position.
Attach the stopper of the reservoir stay [3] against the
groove surface, then tighten the reservoir stay bolt
securely.
[1]
[2]
[1]
[7]
[2]
[3]
[1]
MAINTENANCE
Align
[3]
[4]
[5]
[6]
Attach
3-17