Honda CBR650F Service Manual page 147

dummyhead dummyhead
ELECTRIC STARTER
GROUND LINE
Turn the ignition switch OFF.
Disconnect the starter relay switch 4P (Red) connector
[1].
Check for continuity between the 4P (Red) connector
terminal and ground.
CONNECTION: Green/red – Ground
There should be continuity when the transmission is in
neutral or when the clutch lever is squeezed with the
sidestand retracted (In neutral, there is a slight
resistance due to the diode).
RELAY INSPECTION
Remove the starter relay switch (page 6-8).
Connect a 12 V battery to the starter relay switch as
shown.
There should be continuity between the cable terminals
when the battery is connected, and no continuity when
the battery is disconnected.
REMOVAL/INSTALLATION
Remove the seat (page 2-12).
Disconnect the negative (–) cable from the battery
(page 20-5).
Disconnect the starter relay switch 4P (Red) connector
[1].
Release the terminal cover [2], and remove the socket
bolts [3] to disconnect the cables.
Remove the starter relay switch [4] from the stays [5].
Installation is in the reverse order of removal.
6-8
[1]
[3]
[2]
[1]
[4]
[5]