Honda CBR650F Service Manual page 291

dummyhead dummyhead
FRONT WHEEL/SUSPENSION/STEERING
CB650F/FA
Remove the left handlebar grip and throttle grip (page
16-14).
Straighten the retainer tab [1] with a screwdriver or
punch.
Temporarily install the handlebar weight [3] with the
Apply soapy water
screw [4], aligning the flats, and then remove the inner
through the tab
weight [5] by turning the handlebar weight.
locking hole [2] for
easy removal.
Remove the following from the from the inner weight:
– Screw
– Handlebar weight
– Weight retainer [6]
– Rubber cushions [7]
Install the rubber cushions and a new retainer onto the
inner weight, aligning the inner retainer tabs with the
cushion slit.
Temporarily install the handlebar weight with the screw,
aligning the flats.
Insert the weight assembly into the handlebar. Turn the
handlebar weight and hook the retainer tab with the
hole in the handlebar to secure the inner weight.
Remove the screw while holding the handlebar weight
securely.
Install the left handlebar grip and throttle grip (page 16-
14).
HANDLEBAR GRIP REPLECEMENT
Remove the handlebar weight (page 16-13).
Remove the handlebar grip [1].
Clean the inside surface of the handlebar grip and
outside surface of the handlebar and throttle pipe.
Apply Honda bond A or equivalent to the inside surface
of the grips and to the clean surface of the left
handlebar and throttle pipe.
Wait 3 – 5 minutes and install the grip.
Allow the adhesive
Rotate the grips for even application of the adhesive.
to dry for 1 hour
before using.
Install the handlebar weight (page 16-13).
16-14
[2]
[5]
[3]
[7]
[1]
[1]
[4]
[6]
[1]