Honda CBR650F Service Manual page 321

dummyhead dummyhead
REAR WHEEL/SUSPENSION
Apply molybdenum disulfide grease to a new needle
bearing rotating area.
Install the needle bearing [1] into the right pivot with the
marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
[2] Driver
[3] Attachment, 37 mm
[4] Pilot 30 mm
Install the snap ring [1] into the right pivot groove
securely.
• Do not reuse the snap ring which could easily spin in
the groove.
• Make sure that the snap ring is firmly seated in the
groove.
LEFT SIDE
Press the needle bearing [1] out of the swingarm using
the special tools.
TOOLS:
[2] Remover attachment, 28 mm 07HMC-MR70100
[3] Pilot 17 mm
[4] Attachment, 22 x 24 mm
[5] Driver, 15 x 280L
Apply molybdenum disulfide grease to the rotating area
of a new needle bearing [1].
Carefully press the bearing in the left pivot with the
marked side facing up until the depth from the pivot end
surface is 4.5 – 5.0 mm (0.18 – 0.20 in), using the
special tools.
TOOLS:
[2] Driver
[3] Attachment, 37 mm
[4] Pilot, 28 mm
17-12
07749-0010000
07ZMD-MBW0200
07746-0040700
[5]
07746-0040400
[1]
07746-0010800
07949-3710001
[2]
07749-0010000
07ZMD-MBW0200
07746-0041100 or
07JAD-PH80400
[2]
[3]/[4]
[1]
[1]
[4]
[3]
[2] 4.5 – 5.0 mm
(0.18 – 0.20 in)
[3]
[4]
[1]