Combination Meter - Honda CBR650F Service Manual

dummyhead dummyhead
LICENSE LIGHT REMOVAL/
INSTALLATION
Remove the following:
– Rear fender A (page 2-13)
– Seat (page 2-12)
Disconnect the license light 2P (White) connector [1].
Remove the two nuts [2] and collars [3].
Remove the license light unit [4] by pulling the wire [5]
out from the hole [6] of the rear fender B.
Remove the packing [7] from the license light unit and
replace it with new one if necessary.
Installation is in the reverse order of removal.

COMBINATION METER

INITIAL OPERATION CHECK
When the ignition switch is turned ON with the engine
stop switch " ", the combination meter will show the
entire digital display and the tachometer segments [1]
will increase to full scale, then reduce from full scale to
zero.
• If the MIL [2] stays on and it does not go off, refer to
MIL circuit troubleshooting (page 4-35).
If the digital display does not function at all, inspect the
combination meter power/ground line (page 21-7).
If the power and ground lines are OK, replace the
combination meter (page 21-10).
POWER/GROUND LINE INSPECTION
• The DTC 86-1 (serial communication malfunction)
will be stored in the ECM if the power or ground line
is abnormal. After the service is completed, check
the DTC and erase it (page 4-7).
Remove the combination meter (page 21-10) to
CBR650F/FA:
disconnect
connector [1].
the combination meter
LIGHTS/METERS/SWITCHES
[1]
CBR650F/FA:
16P (Gray)
[1]
[6]
[5]
[2]
[3] [7]
[2]
[1]
21-7
[4]