Honda CBR650F Service Manual page 259

dummyhead dummyhead
CRANKSHAFT/PISTON/CYLINDER
Clean the mating surface of the connecting rods and
crankpin bearing caps with solvent and blow them with
compressed air.
Apply molybdenum oil solution to the crankpin bearing
[1] sliding surfaces on the crankpin bearing caps [2].
Install the crankpin bearing caps by aligning the I.D.
code number on the connecting rod and bearing cap.
Be sure to install each part in its original position, as
noted during removal.
Apply engine oil to the crankpin bearing cap nut [1]
threads and seating surfaces.
Install and tighten the crankpin bearing cap nuts in 2 or
3 steps alternately to the specified torque.
TORQUE: 35.2 N·m (3.6 kgf·m, 26 lbf·ft)
Assemble the crankcase halves (page 13-5).
14-6
[1]
[2]
[1]
Align