Honda CBR650F Service Manual page 234

dummyhead dummyhead
Install the gearshift arm [1] to the gearshift spindle by
aligning the arm slit with the punch mark on the
gearshift spindle.
Install and tighten the pinch bolt [2].
Install the clutch (page 11-9).
GEARSHIFT PEDAL REMOVAL/
INSTALLATION
Remove the pinch bolt [1] and gearshift arm [2] from the
gearshift spindle.
Remove the pivot socket bolt [3] and gearshift pedal [4].
Remove the dust seals [5].
Check the dust seals and tie-rod ball joint dust cover [6]
for deterioration or damage, replace them if necessary.
Installation is in the reverse order of removal.
TORQUE:
Gearshift pedal pivot socket bolt:
27 N·m (2.8 kgf·m, 20 lbf·ft)
• Apply grease to the dust seal lips.
• Install the dust seals with the seal lip side facing out.
• Apply grease to the gearshift pedal pivot sliding area
(grease groove) of the pivot bolt.
• Apply grease to the gearshift pedal tie-rod ball joint.
• Align the slit of the gearshift arm with the punch
mark on the spindle
When adjusting the gearshift pedal height, perform by
loosing the lock nuts [1] and it must be noted as follows.
• The gearshift arm side lock nut has left hand
threads.
Adjust the tie-rod length so that the distance between
the ball joint ends is standard length as shown.
After adjustment tighten the gearshift pedal adjuster
lock nuts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
• Tighten the lock nuts with the position of each ball
joint in parallel to the gearshift arm and gearshift
pedal as shown.
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
[2]
Align
[1]
[1]
Align
[2]
207.7 mm
(8.2 in)
[5]
[3]
[1]
3.5 mm (0.14 in)
3.0 mm (0.12 in)
[1]
[6]
[6] [4]
11-21