Honda CBR650F Service Manual page 397

dummyhead dummyhead
IMMOBILIZER SYSTEM (HISS)
7. Turn the ignition switch ON with a new key or the spare key (Never use the key registered in previous steps). The indicator
comes on for two seconds then it blinks four times repeatedly.
ON
OFF
• The new key or spare key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-7).
• Keep the other transponder key away from the immobilizer receiver more than 50 mm (2.0 in).
8. Repeat the steps 6 and 7 when you continuously register the other new key.
The ECM can store up to four key codes (The four keys can be registered).
9. Turn the ignition switch OFF, remove the inspection adaptor and connect the CKP sensor 2P (Black) connector.
10.Turn the ignition switch ON with the registered key.
• The immobilizer system (HISS) returns to the normal mode.
11.Check that the engine can be started using all registered keys.
When the ignition switch is faulty:
1. Obtain a new ignition switch assembly.
2. Remove the ignition switch (page 21-16).
3. Apply 12 V battery voltage to the CKP sensor lines of the ECM using the special tool (page 22-6).
4. Set the original (registered) key near the immobilizer receiver so that the transponder in the key can communicate with the
receiver.
5. Turn the engine stop switch " ". Connect a new ignition switch to the wire harness and turn it to ON with a new transponder key
(keep the ignition switch away from the receiver). The HISS indicator comes on and it remains on.
• The code of the original key recognized by the ECM.
• If there is any problem in the immobilizer system (HISS), the system will enter the diagnostic mode and the indicator will remain
on for approx. ten seconds, then it will indicate the diagnostic code (page 22-7).
6. Disconnect the red clip of the inspection adaptor from the battery positive (+) terminal for two seconds or more, then connect it
again. The indicator remains on for approx. two seconds then it blinks four times repeatedly.
ON
OFF
• The immobilizer system (HISS) enters the registration mode. Registrations of all key except the original key set near the receiver
are cancelled.
7. Turn the ignition switch OFF and remove the key.
8. Install the ignition switch (page 21-16).
22-4
2 sec.
2 sec.