Honda CBR650F Service Manual page 360

dummyhead dummyhead
ABS MODULATOR
REMOVAL/INSTALLATION
Drain the brake fluid from the rear brake hydraulic
systems (page 18-5).
Remove the following:
– Throttle body (page 7-13)
– ABS modulator cover (page 4-35)
Disconnect the ABS modulator 18P (Black) connector
(page 19-7).
Pull the ECM [1] upward as shown.
Loosen the brake pipe joint nuts [2] to disconnect the
brake pipes.
• When disconnecting, cover the end of the brake
pipes to prevent contamination.
Remove the trim clips [3] and slightly pull the ABS
modulator tray [4] upward.
Remove the following:
– Three washer bolts [5]
– ABS modulator [6] and stay [7]
– Three collars [8]
Installation is in the reverse order of removal.
• Apply brake fluid to the threads of the brake pipe
joint nuts.
TORQUE:
Brake pipe joint nut: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Fill and bleed the front and rear brake hydraulic
systems (page 18-6).
ANTI-LOCK BRAKE SYSTEM (ABS; CBR650FA, CB650FA)
[2]
[7]
[1]
[8]
[4]
[6]
[5]
[3]
[5]
19-23