Honda CBR650F Service Manual page 343

dummyhead dummyhead
ANTI-LOCK BRAKE SYSTEM (ABS; CBR650FA, CB650FA)
DTC INDICATION PATTERN
• The ABS indicator indicates the DTC by blinking a specified number of times. The indicator has two types of blinking, a long
blink and short blink. The long blink lasts for 1.3 seconds, the short blink lasts for 0.3 seconds. For example, when one long blink
is followed by two short blinks, the DTC is 1-2 (one long blink = 1 blink, plus two short blinks = 2 blinks).
• When the ABS control unit stores some DTCs, the ABS indicator shows the DTCs in the order from the lowest number to highest
number. For example, when the ABS indicator indicates DTC 1-2, then indicates DTC 2-3, two failures have occurred.
ON
IGNITION
SWITCH
OFF
ON
ABS
INDICATOR
OFF
When the DTC is not stored:
ON
ABS
INDICATOR
OFF
ERASING STORED DTC
• The stored DTC can not be erased by simply disconnecting the battery negative cable.
Erase the DTC with the MCS while the engine is stopped.
How to erase the DTC without MCS
1. Connect the SCS connector [1] to the DLC (page 19-5).
2. While squeezing the brake lever, turn the ignition switch ON with the
engine stop switch to " ". The ABS indicator should come on for 2
seconds and go off.
3. Release the brake lever immediately after the ABS indicator goes off.
The ABS indicator should come on.
4. Squeeze the brake lever immediately after the ABS indicator comes on.
The ABS indicator should go off.
5. Release the brake lever immediately after the ABS indicator goes off.
When the DTC is erased, the ABS indicator blinks 2 times and stays on.
If the ABS indicator does not blink 2 times, the self-diagnostic memory
has not been erased, so try again.
6. Turn the ignition switch OFF and remove the SCS connector from the
DLC.
Install the seat (page 2-12).
19-6
1.3 sec.
2 sec.
3.6 sec.
DTC start
signal
0.4 sec.
Lowest number DTC
(Example: 1-2)
2 sec. 3.6 sec.
1.3 sec.
1.3 sec.
0.3 sec.
3.6 sec. 0.5 sec.
Highest number DTC
(Example: 2-3)
Pattern repeated
[1]