Honda CBR650F Service Manual page 296

dummyhead dummyhead
Tighten the bottom bridge pinch bolt [1] to the specified
torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Tighten the fork cap [2] to the specified torque if it was
removed.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Tighten the top bridge pinch bolt [3] to the specified
torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
Install the handlebar [1] over the fork tube, aligning the
boss with the groove in the top bridge.
Be sure the handlebar holder is fully seated on the top
bridge. Push the handlebar forward to touch the boss
against the inside of the groove, then tighten the pinch
bolt [2] to the specified torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the stopper ring [3] into the groove in the fork
tube.
Secure the horn wire [1] to the left fork pipe with the
wire band [2].
Install the following:
– Front fender (page 2-5)
– Front wheel (page 16-15)
REMOVAL (CB650F/FA)
Remove the following:
– Front wheel (page 16-15)
– Front fender (page 2-5)
– Headlight assembly from the bottom bridge (page
21-3)
Loosen the top bridge pinch bolt [1].
When the fork is ready to be disassembled, loosen the
fork cap [2], but do not remove it.
Support the fork leg securely.
Loosen the bottom bridge pinch bolt [3] and pull the fork
leg down, then remove it out of the top and bottom
bridges.
FRONT WHEEL/SUSPENSION/STEERING
[1]
[2]
Align
[1]
[2]
[3]
[2]
[3]
[3]
[1]
[2]
[1]
16-19