Table of Contents
Advertisement
Programming Instructions
Programming Instructions for System Options
Goal
Program System Options including time and date, tamper, siren, timers, and
service settings.
Pre-conditions
Time and date are automatically updated using an Internet time server by default,
this setting is enabled under Communicator > IP Config.
If you want to allow xGenConnect to send diagnostic emails then check email is
set up correctly under Communicator > Email and xGenConnect is connected to
a network.
Note:
Ensure you set the correct time zone here.
Programming Sequence
2. System
a) System Clock
b) System and Siren
c) Timers
d) Maintenance and Test
Instructions
1. Open System
2. Select the right Time Zone using the Hours and minutes offset
98
xGenConnect Installation and Programming Guide
Hide quick links:
Advertisement
Table of Contents
