Sequence Reprocessing Using The Navigation Table - Agilent Technologies 8453 Operator's Manual

2 Review your data using the sequence method: Use the option Sequence
3 Review your data using a different method: If you want to use a different
For LC, CE, LC/MS and CE/MS systems, the option Individual Method from Data File
N O T E
(DA.M) is selected by default.
For GC systems, the option Current Method is selected by default.

Sequence Reprocessing Using the Navigation Table

Sequence data acquired with ChemStation revisions up to B.01.03 need to be reprocessed
N O T E
using the reprocess option in the Method and Run Control view. The same applies to data
acquired in B.03.01 when Unique Folder Creation is switched off.
Sequence data acquired with ChemStation revisions B.02.01 and higher need to be
reprocessed using the reprocessing toolset in the Data Analysis Navigation Table.
For reprocessing using the Navigation Table in Data Analysis, all necessary files
are present in the sequence data container:
• sequence data files (*.d)
• all methods (*.m) files used during the sequence
• copy of the original sequence template (*.s)
Understanding Your Agilent ChemStation
is visible in the Status Bar; the system adds from data file in brackets (from
data file) to indicate that the loaded method is the individual method for
the data file.
Method in the Preferences / Signal/Review Options to have the system load the
sequence method corresponding to the current line of the Navigation Table.
This method is loaded whenever a data file is loaded and is used for
reviewing and generating the report. The method name is visible in the
Status Bar; the system adds sequence in brackets (sequence) to indicate
that the loaded method is the sequence method corresponding to the
current line of the Navigation Table.
method for reviewing the data than the individual data analysis method
(DA.M) stored with the data file or the sequence method, the option current
method in Preferences / Signal/Review Option must be selected. In this case,
the system uses the currently loaded method for reviewing and generating
the report. The method name is visible in the Status Bar.
Data Review, Reprocessing and Batch Review
Navigation Table in Data Analysis
9
205