Agilent Technologies 8453 Operator's Manual page 225

Figure 35
SIMM memory modules
5 Remove the memory module and repeat the last step in case there is a second
1 Place the memory module in the SIMM socket on the SPM board that the
2 Press the memory module towards the front of the spectrophotometer that it
3 Replace the upper rear foam block.
4 If available, replace any accessory board or MIO board (plugged in from the
5 Replace the plastic and sheet metal rear cover. Push the plastic rear cover
6 Reconnect line power and turn on the instrument. Check that the
Maintenance and Repair
Exchanging or Upgrading Internal Memory
Removing SIMM Memory Modules
memory module installed.
Replacing SIMM Memory Modules
components of the memory module are facing to the rear of the
spectrophotometer. The memory module is now positioned at an angle in the
SIMM socket.
snaps in behind the two springs on either side of the SIMM socket.
rear side of the instrument).
down so that it locates on both sides, see "Removing and Replacing Covers"
on page 109.
spectrophotometer passes its self-test,this means that the green light on the
front panel comes on and that you can do a blank measurement from your
software.
119