Agilent Technologies 8453 Operator's Manual page 374

4
Integration
Baseline Allocation
B The peak started or stopped on the baseline.
V The peak started or stopped with a valley drop-line.
P
The peak started or stopped while the baseline was penetrated.
H
The peak started or stopped on a forced horizontal baseline.
F
The peak started or stopped on a forced point.
M
The peak was manually integrated.
U
The peak was unassigned.
Additional flags may also be appended (in order of precedence):
Character 3
D
The peak was distorted.
A
The integration was aborted.
U
An under-range condition occurred.
O
An over-range condition occurred.
Character 4
The fourth character describes the peak type:
S
The peak is a solvent peak.
N
The peak is a negative peak.
+
The peak is an area summed peak.
T
Tangent-skimmed peak (standard skim).
X
Tangent-skimmed peak (old mode exponential skim).
E
Tangent-skimmed peak (new mode exponential skim).
m
Peak defined by manual baseline.
n
Negative peak defined by manual baseline.
t
Tangent-skimmed peak defined by manual baseline.
R
The peak is a recalculated solvent peak.
100 Understanding Your Agilent ChemStation