Agilent Technologies 8453 Operator's Manual page 205

1 Holding the lamp(s) at the lamp ring, carefully slide it into the lamp housing,
Figure 15
Recessment at
deuterium lamp
2 Take a Pozidriv screwdriver and fix the two screws which fix each lamp.
3 Connect the plug(s) of the lamp(s) to the electronic board, see Figure 14.
4 Slide in the metal door and close so that it is locked. Close the plastic door.
Figure 16
Maintenance and Repair
Exchanging the Deuterium or Tungsten Lamp
Replacing the Deuterium or Tungsten Lamp
and avoid touching the quartz envelope of the deuterium lamp, see CAUTION
on page 98. The tungsten lamp ring has a flat part which has to show towards
the deuterium lamp location. The deuterium lamp has a recessment for a
location pin on the lamp housing.
Replacing the Lamps
There is only one way to get the plug(s) in.
Sliding In and Closing the Metal Door and Closing
Flat part at tungsten lamp
99