Agilent Technologies 8453 Operator's Manual page 584

4
Workflow with Unique Folder Creation switched off
Workflow with Unique Folder Creation switched off
Selecting Unique Folder Creation Off has the following impact on data storage:
• Sequence data are not acquired into a sequence container, but directly
• This means that for two or more sequence acquisitions the data may be
• No sequence methods (.M) or copies of the sequence file (.S) are stored
• There are no data file specific methods ACQ.M and DA.M stored. Saving
38
into the subdirectory as specified in the Sequence Parameters (
on page 14). Therefore, the sequence name pattern is grayed out on the
Sequence tab of the Preferences dialog (
acquired into the same subdirectory. This implies the risk to overwrite
existing data, but on the other hand allows to split sequences using
partial sequence execution and still combine the results in one folder
(which would not be possible with Unique Folder Creation switched
on).
with the data, but only the sequence logfile and the batch file (.B). This
means only the methods and sequences in the paths specified in the
Preferences dialog (
used for acquisition as well as for data review and reprocessing.
Sequence or data file specific method changes can only be stored by
saving the method with different name. Otherwise these changes are
also applied to the acquisition method. On the other hand, this may be
desired behavior during method development.
information about the original acquisition is only possible by including
this information in the report or by selecting Save Method with Data from
the method's runtime checklist
the acquisition method will be stored as RUN.M in each data file.
Figure 2 on page 12) are available. They have to be
(Figure 19
Figure 18 on page 37).
on page 39). With this option
ChemStation Workflow
Figure 4