Display Messages - GE Logiq 500 User Manual

Troubleshooting

Display Messages

The LOGIQ
the status of the system's operation.
S
S
S
S
S
These messages are displayed in the single line message area
at the bottom of the display. The message display time varies
depending on the type of message. Some messages may be
accompanied by an audio tone.
For Operation Error Messages, the user can choose to turn
on/off the audio tone that accompanies the display in the Set
Up/System Parameters page 1.
The User can turn on/off the recording of the error message line
in the Set Up/System Parameters page 5 (Maskline Record).
The following tables outline the error messages, their possible
cause and cure.
16–26
500 provides a variety of messages concerning
System Error Messages are displayed when a hardware
problem is detected.
Operation Error Messages are displayed when the user
selects a control that is not appropriate to the current scan
mode or function.
Operation Guide Messages are displayed to inform the
operator of a completed task or required action.
Warning Messages are displayed for patient safety or
system failure reasons.
System Preparation Message is displayed when the system
powers up.
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0