Imaging Parameter 2 - Probe Dependent 2) - GE Logiq 500 User Manual

Page 2 of 18 (Imaging Parameter 2 – Probe Dependent 2)
B Gain EC, UP, P, R
Choose the default gain value for B-Mode.
Value from 0 to 98 in 2 digit increments. The maximum value is probe dependent and
may not reach 98.
B Dynamic Range EC, UP, P, R
Choose the default dynamic range value for B-Mode.
Value from 30 to 90 in 6 digit increments.
B Edge Enhance EC, UP, P, R
Choose the default edge enhancement value for B-Mode.
Off, Low, Mid or High.
B Image Softener EC, UP, P, R
Choose the B-Mode image softener function default.
On or Off.
B Softener Level EC, UP, P, R
Choose the B-Mode image softener default level.
D1, D2, D3, Low, Mid or High.
B Frame Average EC, UP, P
Choose the B-Mode frame averaging default value.
Off (no frame averaging), 1, 2, 3, 4, 5 or 6.
B Image Frequency EC, UP, P, R
Choose the B-Mode image frequency optimization setting.
Resolution
Normal
Penetration
Further Penetration
Harmonic1
Harmonic2
The soft menu display shows this parameter as an imaging frequency depending on the
active probe.
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0
Process image for best resolution.
Compromise between resolution and penetration.
Process image for penetration.
C358 Probe Only—Process image for more penetration
S222, S317 and C358 Probes Only—Process image with
tissue harmonic frequency.
S222, S317 and C358 Probes Only—Process image with
tissue harmonic frequency.
Custom Display
14–15