Error Messages - GE Definium 5000 Operator's Manual

Error Messages

Error messages indicate the potential cause of a system failure. They are shown on the touch screen
panel or acquisition workstation. (Refer to Table 3-9.)
Table 3-9 Error Messages
Error
Description (in screen)
Number
1 Initialize EEPROM in Service Mode
2 EEPROM could not be initialized
3 Move without Order: Call Service
4 Fatal RAM ERROR: Call Service
5 Movement Order active during
Start-up
6 Security: Call Service
7 Initial Gauge Check: Restart
8 Communication Lost
9 Inconsistent Relay Input
10 Order without move
11 Potentiometer
12 Calibration
13 External
14 Potentiometer out of Range
15 Movements locked
16 Move Button Released
17 Incompatible Movements
18 Opposite Move
Definium 5000 X-Ray System
Operator Manual
Turn the unit Off and On. if error remains, call field
service.
Press the RESET ERROR button on the Touch Screen
Console.
Turn the Unit OFF and call field service.
Turn the Unit OFF/ON, if error remains, call field
service.
Press the Safety Lock button
Operator stopped pressing the Auto positioning
button. Press and hold until auto positioning has
finished.
A movement button has been pressed while auto
positioning was in progress. Release the movement
button.
An opposite movement button has been pressed
while other movement was in progress. Release the
opposite movement button.
5197809-1EN Rev. 4 (13 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter 3: System Overview
What To Do
3-27