Annotating An Image; Introduction - GE Logiq 500 User Manual

Annotating an Image

Introduction

The annotation keyboard is always active. Upon starting a new
patient or power up, the underscore cursor appears in the
mode's home position. Annotation can commence after using
the Trackball to specify where the comment should start.
Pressing the Comment key assigns the trackball function to
controlling the cursor and displays the annotation library in the
soft menu.
The Comment key enables the image text editor and displays
the annotation library soft menu. After the Comment key is
pressed, text can be added through the Soft Menu comment
.
library or by typing comments from the alphanumeric keyboard.
Turning off the cursor can be done by pressing the Set key.
Pressing the Clear key erases all comments.
NOTE: If the "Use A/N Keys for User Define" preset in
Set Up/System Parameters page 3 is ON, the Comment key
must be pressed first to activate the annotation function.
1
Figure 6–12. Annotation Cursor in Home Position
6–16
Annotating an Image
1 Underscore Cursor or Block
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0