Probes; Introduction; Connecting The Probe - GE Logiq 500 User Manual

Introduction

Only use approved probes.
All imaging probes can be plugged into any of the three probe
ports.
For more
Refer to the Probes chapter.
information

Connecting the Probe

Probes can be connected at any time, regardless of whether
the console is powered on or off. To ensure that the ports are
not active, place the system in the image freeze condition.
To connect a probe:
CAUTION
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0
1. Place the probe's carrying case on a stable surface and
open the case.
2. Carefully remove the probe and unwrap the probe cord.
3. DO NOT allow the probe head to hang free. Impact to
the probe head could result in irreparable damage.
4. Turn the connector locking handle counterclockwise.
5. Align the connector with the probe port and carefully
push into place.

Probes

Probes
3–29