Cursors; General Mode Measurements Method - GE Logiq 500 User Manual

Hide thumbs Also See for Logiq 500:

Table of Contents

Introduction

Cursors

During the measurement process, the fixed and active cursors

can either be an "X" or "+" symbol. The "Active Measurement

Cursor" preset, located on System Parameters page 3, allows

for the choice of the Measurement cursor.

Once the measurement sequence is complete, the cursor

symbol changes to one of the eight shown below.

Figure 7–2. Measurement Completed Cursors

When performing measurements, it is possible to choose the

display of and location of the caliper for subsequent

measurements while in B, M or Doppler modes. These presets

( "B Auto Caliper Control" , "M Auto Caliper Control" and "D Auto

Caliper Control" ) are located on Preset Program page 4.

500 Basic Users Manual

2233658–100 Rev. 0