Imaging Parameter 6 - Probe Dependent 6) - GE Logiq 500 User Manual

Page 6 of 18 (Imaging Parameter 6 – Probe Dependent 6)
CFM Color Threshold EC, UP, P, R
Choose a priority level for B-Mode display during CFM mode. The higher the number,
the greater the emphasis on CFM Mode (color) verses B-Mode (gray scale).
Level from 0 to 100 in 1 digit increments.
CFM Threshold Velocity
Choose the level above which color will no longer be used to display velocity.
Level from 0 to 25 in 1 digit increments.
CFM Threshold Turbulence
Choose the level above which color will no longer be used to display turbulence.
Level from 0 to 100 in 1 digit increments.
CFM Wall Echo Canceller
Choose the initial default setting of the wall echo cancel function.
On or Off.
CFM/PDI Spatial Filter EC, UP, P
Choose the desired amount of averaging between color pixels.
Off
Low
Mid
High
CFM Target Frame Rate
Choose the desired frame rate range while in CFM mode.
Density
Low
Mid
High
CFM Target Frame Rate Dtl
Choose the desired frame rate range while in the Detail (Dtl) Mode of CFM presentation.
Density
Low
Mid
High
CFM Packet Size Survey, Map, SrvyDtl and MpDtl
Choose the default packet size for each CFM diagnostic mode display. This will be for
Survey Mode, Map Mode, Survey-Detail Mode and Map-Detail Mode.
Small
Mid
Large
NOTE: The higher the packet size, the better the color presentation but with a slower
frame rate.
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0
EC, UP, P, R
EC, UP, P, R
EC, UP, P, R
No spatial filtering.
Low spatial filtering.
Medium spatial filtering.
Maximum spatial filtering.
EC, UP, P
Lowest frame rate for high color density
Low frame rate for CFM.
Medium frame rate for CFM.
High frame rate for low color density.
EC, UP, P
Lowest frame rate for high color density
Low frame rate for CFM Detail Mode.
Medium frame rate for CFM Detail Mode.
High frame rate for CFM Detail Mode.
EC, UP, P
Small packet size.
Medium packet size.
Large packet size.
Custom Display
14–23