Powering On The System; Connecting And Using The System - GE Logiq 500 User Manual

Powering On the System

Connecting and Using the System

To connect the system to the electrical supply:
To avoid risk of fire, the system power must be supplied from a
WARNING
separate, properly rated outlet. See Site Requirements, Before
the system arrives on 3–3 for rating information.
Under no circumstances should the AC power plug be altered,
changed, or adapted to a configuration rated less than
specified. Never use an extension cord or adapter plug.
To help assure grounding reliability, connect to a "hospital
grade" or "hospital only" grounded power outlet.
Plug
120 VAC, 1350 VA
Plug and Outlet Configuration
(USA)
Figure 3–8. Example Plug and Outlet Configurations
3–16
Powering On the System
1. Ensure that the wall outlet is of the appropriate type.
2. Ensure that the power switch is turned off.
3. Unwrap the power cable. Make sure to allow sufficient
slack in the cable so that the plug is not pulled out of
the wall if the system is moved slightly.
4. Push the power plug securely into the wall outlet.
Outlet
Plug
Outlet
220–240 VAC, 1350 VA
Plug and Outlet Configuration
(Europe)
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0