Imaging Parameter 1 - Probe Dependent 1) - GE Logiq 500 User Manual

Page 1 of 18 (Imaging Parameter 1 – Probe Dependent 1)
Enter Depth EC, UP, P, R
Choose the desired default display depth for the probe indicated.
4, 5, 6, 7, 8, 10, 12, 14, 16, 18, 20, 22 or 24 cm.
Focus Depth [mm] EC, UP, P, R
Choose the desired default focus depth for the probe indicated.
Depth from 1 to 240 mm in 1 mm increments.
Image Rotation EC, UP, P, R
Choose the desired default image orientation.
0 (N) Normal top to bottom orientation.
90 ° left to right orientation.
90 (W)
180 (S) Inverted bottom to top orientation.
270 ° right to left orientation.
270 (E)
Image Reverse EC, UP, P, R
Choose the initial default setting of image reverse (left-right orientation).
On or Off.
Zoom Auto Start EC, UP, P
Choose to automatically place the image into the zoom mode after a probe selection
change.
Off No auto zoom at probe change.
On Auto zoom mode at probe change.
Zoom Reference EC, UP, P
Choose the zoom reference image default setting.
On or Off.
Zoom Factor EC, UP, P, R
Choose the default zoom factor for the read (freeze) zoom.
1.0, 1.2, 1.5, 2.0, 2.5, 3.0 or 4.0.
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0
Custom Display
14–13