Trace Auto; Flow Volume Output (Fvo); Helpful Hints - GE Logiq 500 User Manual

General Calculations

Trace Auto

Use the Trace Auto Sub-Menu selection to turn on/off the
Doppler Auto Trace function. See 10–28 for more details.

Flow Volume Output (FVO)

This measurement is used to measure the flow volume output
in a vessel on the Doppler spectrum. It is measured in
milliliters/minute. When the FVO measurement is made, FV is
automatically calculated.
Refer to the FV measurement on 8–7 for details.

Helpful hints

The following hints can help when taking a measurement:
Hints
S
S
S
S
S
8–8
If PRINT is pressed while making a measurement, the
system completes the measurement and sends the data to
the report page (unless the VCR is assigned to the PRINT
key).
Prior to making measurements, use the Cine function, if
necessary, to display the best image.
Measurements can continue to be made until all
measurement/calculation cells are filled. The cells are
displayed at the bottom center of the display.
Once all measurement/calculation cells are filled on the
display, any further measurements will cause the top (first)
cell to be erased and the new measurement added last
("first in, first out").
If there is a series of measurements/calculations that are
routinely taken in a specific sequence, the auto sequence
feature of the system can be used to program these
measurements/calculations to automatically appear on the
display in the desired order. Refer to 14–80 for details on
programming an auto sequence.
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0