Exam Application Preset Selection; Introduction; Selecting A Probe - GE Logiq 500 User Manual

Exam Application Preset Selection

Introduction

Select the exam category application preset, that best
describes the desired study to be performed, from the factory
default preset selections displayed on the Soft Menu.
A typical example for OB is shown in Figure 4–2.
General
Use these parameters as a starting point for the exam.

Selecting a probe

S
S
The "Change Probe and Category" preset, found on System
Parameters page 1, allows the exam category to automatically
change depending on the probe selected.
Some probes are used in more than one exam category. If the
default for "Change Probe and Category" is set to Simultaneous
and the wrong exam category is automatically activated, press
ID/Name to select the correct exam category.
LOGIQ 500 Basic Users Manual
2233658–100 Rev. 0
Exam Applic. Preset Selection
Fetal
OB Heart
Tech Newborn
Diff
Figure 4–2. OB Preset Selection
Always start out with a probe that provides optimum focal
depths and penetration for the patient size and application.
Begin the scan session using the default Acoustic Output
setting for the probe and application.
4–7