Redistribute Ospf - Dell C9000 Series Reference Manual

redistribute ospf

Redistribute OSPF routes into BGP.
C9000 Series
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id
match external {1 |
2}
match internal
route-map map-
name
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
7.8.1.0
7.7.1.0
Enter the number of the OSPF process. The range is from 1 to
65535.
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
(OPTIONAL) Enter the keywords match internal to
redistribute OSPF internal routes only.
(OPTIONAL) Enter the keywords route-map then the name of a
configured route map.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol 499