Neighbor Password - Dell C9000 Series Reference Manual

Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its
configuration takes precedence over the neighbor next-hop-self command.

neighbor password

Enable message digest 5 (MD5) authentication on the TCP connection between two neighbors.
C9000 Series
Syntax
neighbor {ip-address | peer-group-name} password [encryption-type]
password
To delete a password, use the no neighbor {ip-address | peer-group-name}
password command.
Parameters
ip-address
peer-group-name
encryption-type
password
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Enter the IP address of the router to be included in the peer
group.
Enter the name of a configured peer group.
(OPTIONAL) Enter 7 as the encryption type for the password
entered. 7 means that the password is encrypted and hidden.
Enter a text string up to 80 characters long. The first character
of the password must be a letter.
You cannot use spaces in the password.
Border Gateway Protocol 477