Paper Roll; Cut Paper; Notes On Using Translucent Paper; Hemmed Paper - Ricoh LW5100en Operating Instructions Manual

4. Appendix

Paper roll

• If humidity is high, and the paper roll has expanded due to moisture, be sure to cut off
approximately 1000 mm (40"), before making copies or printing.
• Use a paper roll that has a black core.
• When a paper roll of 90 g/m
paper left on the roll, image may be faint near the leading and/or trailing edge, or an image may
be doubled. To prevent this, set 3-5 mm (0.11"- 0.19") margins from the leading and trailing
edges.
• p.57 "Anti-humidity Heater Switch"
• "Margin Adjustment", Copy/Document Server Reference

Cut paper

• Straighten curled or warped paper before loading.
• To prevent multiple-sheet fed simultaneously, fan the paper before loading it in the tray.
• Do not load paper over the limit mark of the paper tray.
• Make sure the paper edges of the sheets are aligned to the front of the paper tray.
• Load translucent paper lengthways when possible.
• If the output copies are badly curled, turn the paper loaded in the cut paper trays upside down, or
remove the copies during the copy run.

Notes on using translucent paper

Smooth out any curls in the paper before loading it.
Load translucent paper lengthways when possible.

Hemmed paper

When using hemmed paper, wrinkles and other problems may occur on paper.
Use the following procedure when copying or printing onto hemmed paper:
• Use the bypass tray.
• Make sure the paper is straight, and align the paper guides of the bypass tray to the paper size.
• Load only one sheet at a time.
90
2 2
(24 lb) or 110 g/m (29.3 lb) paper is used and there is little