Initialize Td Sensor And Developer; Set Paper Size For Paper Trays; Electrical Total Counter - Ricoh D129 Service Manual

Main Machine Installation

Initialize TD Sensor and Developer

1. Connect the main machine to the power outlet, switch on the main machine, and wait for
the fusing unit to warm up.
2. Enter Copy SP Mode.
3. Press SP Direct to highlight "SP Direct", enter 2801, and then press
4. When the message prompts you to enter the lot number of the developer, enter the 7-digit
lot number, press
initializes the TD sensor. It takes 60 to 90 sec.

The lot number is printed on the end of the developer package. Recording the lot
number could help troubleshoot problems later. If the lot number is unavailable,
enter any seven-digit number.
5. Press SP Direct to highlight "SP Direct" and enter 2805, press
"Execute" on the touch-panel. This initializes the developer.
6. Press "Exit" twice to return to the copy window.

Set Paper Size for Paper Trays

1. Press User Tools/Counter
2. On the touch panel, press "System Settings".
3. Press the "Tray Paper Settings" tab.
4. Press the button for the tray to change.
5. Change the setting and press the [OK] button.
6. Repeat for each tray installed.
7. Press Exit twice to return to the main display

The 1st, 2nd, 3rd, and 4th paper trays are provided with the paper size switches. The
detected paper size by the paper size switches has priority over the UP settings.
However, if you change the "Auto Detect" with the UP setting, you can select the paper
size.
8. Check the copy quality and machine operation.

Electrical Total Counter

The electrical total counter no longer requires initialization. The new incrementing counter is set
to "0" at the factory.
D129/D130
on the touch-panel. Press [Yes], and then press [Execute]. This
.
2-14
.
, and then press
SM