Introduction; Outline Of Product; Features - Mitsubishi MELSEC-F FX-10DM-E User Manual

FX-10DM-E DISPLAY MODULE
1.

Introduction

This section describes the product configuration and the system configuration of the FX-
10DM-E (hereafter referred to as "10DM"). Make sure that all accessories are included in the
package before using the 10DM. (Refer to Paragraph 1.6.)
1.1

Outline of product

The 10DM is mounted on the surface of the control panel
or the operation panel, and connected to the program-
ming connector of the FX Series PLC located inside the
control panel or the operation panel.
The 10DM is a small display module with which you can
monitor word devices of the PLC and change the data
using the switches of the 10DM while looking at the dis-
play unit of the 10DM.
1.2

Features

1) The STN character type liquid crystal display unit with
LED backlight displays "16 characters x 2 lines", and
is easy to look at.
2) As to data registers (D), up to 2 points of 16- or 32-bit data can be displayed and changed in
signed decimal numbers.
3) As to counters (C) and timers (T), the current value and the set value can be displayed and
changed.
4) The setting of the entry monitor and the system setting information stored in the EEPROM
is held against power interruption.
Introduction 1
FX Series
PLC
Programming
connector
10DM main
body
1-1
1.Introduction
2.Specifica-
tions
3.Installation
Wiring
Maintenance
4."SYSTEM
MODE"
Menu
5.Environ-
mental
Setting
"MONITOR
SET"
"OTHER"
6.Display
"ENTRY
MONITOR"
DEVICE
MONITOR
7.Attachment
ASCII codes
Setting sheet
Error mes-
sage list