Switches And Jumpers On The Terminal Board - YASKAWA A1000 Technical Manual

 Switches and Jumpers on the Terminal Board
The terminal board is equipped with several switches used to adapt the drive I/Os to the external control signals.
Figure 3.27 shows the location of these switches. Refer to
Figure 3.30
Slide Switch S6
Terminal DM+,DM-
N.C./N.O. Selection
Jumper S3
Terminal H1/H2
Sink/Source Sel.
DIP Switch S2
RS-422/485 Termination
Off
<1> Available slide switch S6 is models ETC740310 and ETC740311.
N.O. N.O.
N.C. N.C.
ETC740310 ETC740311
YASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual
<1>
N.O.
N.C.
Resistor
On
Figure 3.27 Locations of Jumpers and Switches on the Terminal Board
Control I/O Connections on page 88
E(G) HC H1 H2 DM+ DM- IG R+ R- S+ S-
M3 M6 M4
V+ AC V- A1 A2 A3 FM AM AC MP RP AC
M1 M2 M5
S1 S2 S3 S4 S5 S6 S7 S8 SN SC SP MA MB MC
3.9 Control Circuit Wiring
for setting instructions.
DIP Switch S1
Terminal A2 Signal
Selection
V I
Jumper S5
Terminal AM/FM Signal
Selection
V
I
FM AM
DIP Switch S4
Terminal A3 Analog/
PTC Input Sel.
PTC
AI
3
87