3.8 Control Circuit Wiring
◆ Switches and Jumpers on the Terminal Board
The terminal board is equipped with several switches used to adapt the drive I/Os to the external control signals.
Figure 3.22
shows the location of these switches. Refer to
Figure 3.26
74
Jumper S3
Terminal H1/H2
Sink/Source Sel.
DIP Switch S2
RS-422/485 Termination
Resistor
Off
On
Figure 3.22 Locations of Jumpers and Switches on the Terminal Board
Control I/O Configuration on page 75
YASKAWA ELECTRIC SIEP C710616 38A YASKAWA AC Drive L1000A Technical Manual
for setting instructions.
YEA_c
ommon