Switches And Jumpers On The Terminal Board - YASKAWA A1000 Series Technical Manual

3.9 Control Circuit Wiring

◆ Switches and Jumpers on the Terminal Board

The terminal board is equipped with several switches used to adapt the drive I/Os to the external control signals.
Figure 3.28 shows the location of these switches. Refer to
Figure 3.32
DIP Switch S1
Terminal A2 Signal
Terminal H1/H2
Sink/Source Sel.
DIP Switch S2
RS-422/485 Termination
76
Selection
V I
Jumper S3
Resistor
Off On
Figure 3.28 Locations of Jumpers and Switches on the Terminal Board
Control I/O Connections on page 77
E(G) HC H1 H2 DM+ DM- IG R+ R- S+ S-
M3 M6 M4
V+ AC V- A1 A2 A3 FM AM AC MP RP AC M1 M2 M5
S1 S2 S3 S4 S5 S6 S7 S8 SN SC SP MA MB MC
YASKAWA ELECTRIC SIEP C710616 27C YASKAWA AC Drive A1000 Technical Manual
for setting instructions.
YEG
Jumper S5
Terminal AM/FM Signal
Selection
V
I
FM AM
DIP Switch S4
Terminal A3 Analog/
PTC Input Sel.
PTC
AI