Switches And Jumpers On The Terminal Board - YASKAWA GA800 Programming Manual

4.
Install the LED status ring board, front cover, and the keypad to their initial positions.
◆

Switches and Jumpers on the Terminal Board

The terminal board has switches to adapt the drive I/Os to the external control signals as shown in
Set the switches to select the functions for each terminal.
Posi-
Switch
tion
A DIP switch S2
B Jumper switch S5
DIP switch S1-1
C DIP switch S1-2
DIP switch S1-3
D Dip switch S4
YASKAWA TOEPYAIGA8002B GA800 Drive Programming
Figure 4.27 Locations of Switches
Table 4.10 I/O Terminals and Switches Functions
Terminal
Enables and disables the MEMOBUS/Modbus communications
-
termination resistor.
FM, AM Sets terminals FM and AM to voltage or current output.
A1 Selects the input signal type (voltage/current).
A2 Selects the input signal type (voltage/current).
A3 Selects the input signal type (voltage/current).
A3 Selects MFAI or PTC input.
Function
4.5 Control Circuit Wiring
Figure 4.27.
Default Setting
OFF
FM: V (voltage output)
AM: V (voltage output)
V (voltage input)
I (current input)
V (voltage input)
AI (analog input)
4
631