Switches And Jumpers On The Terminal Board - YASKAWA E1000 Technical Manual

◆ Switches and Jumpers on the Terminal Board

The terminal board is equipped with several switches used to adapt the drive I/Os to the external control signals.
Figure 3.29 shows the location of these switches. Refer to
Figure 3.36
DIP Switch S1
Terminal A2 Signal
Terminal H1/H2
Sink/Source Sel.
DIP Switch S2
RS-422/RS-485
Termination Resistor
YASKAWA ELECTRIC SIEP C710616 35D YASKAWA AC Drive E1000 Technical Manual
Selection
V I
Jumper S3
Off On
Figure 3.29 Locations of Jumpers and Switches on the Terminal Board
Control I/O Connections on page 86
Terminal AM/FM Signal
Terminal A3 Analog/
3.9 Control Circuit Wiring
for setting instructions.
YEC_comon
Jumper S5
Selection
V I
AM
FM
DIP Switch S4
PTC Input Sel.
PTC
AI
3
85