Digital Operator Remote Usage - YASKAWA A1000 Technical Manual

2.2 Mechanical Installation
 Digital Operator Remote Usage

Remote Operation
The digital operator mounted on the drive can be removed and connected to the drive using a remote control extension
cable up to 3 m long. This makes it easier to operate the drive when it is installed in a location where it can not be
accessed easily.
The digital operator can also be permanently mounted in a remote location like a panel door. A remote control extension
cable and an installation support set (depending on the installation type) will be required.
Note: Refer to Drive Options and Peripheral Devices on page 414
support sets.
Figure 2.9

Digital Operator Remote Installation
Digital Operator Dimensions
Figure 2.10
Installation Types and Required Materials
There are two ways the digital operator can be mounted to an enclosure:
1.
External/face-mount installs the operator outside the enclosure panel
2.
Internal/flush-mount installs the operator inside the enclosure panel
Installation Method
Simplified installation with the digital
External/Face-Mount operator is mounted on the outside of
the panel with two screws.
Encloses the digital operator in the
Internal/Flush-Mount panel. The digital operator is flush
with the outside of the panel.
50
Drive
Figure 2.9 Communication Cable Connection
60
Figure 2.10 Digital Operator Dimensions
Table 2.2 Digital Operator Installation Methods and Required Tools
Description Installation Support Sets
Installation Support Set A
(for mounting with screws through
holes in the panel)
Installation Support Set B
(for use with threaded studs that are
fixed to the panel)
for information on remote control extension cables and installation
Operator
Comm Port
S / N : J007XE273710001
Communication Cable Connector
Installation holes (2-M3 screws, depth 5)
12.2 1.6
7.9
minimum
50
–
YASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual
S / N : J007XE273710001
44
Unit: mm
Model
– Phillips screwdriver (#1)
EZZ020642A Phillips screwdriver (#1, #2)
Phillips screwdriver (#1)
EZZ020642B
Required Tools
Wrench (7 mm)