Switches And Jumpers On The Terminal Board - YASKAWA CIPR-GA50C series Technical Manual

3.5 Control Circuit Wiring
A - Connect the shield to terminal E
B - Sheath
3.
Attach the front cover.
If you moved Jumper S5, attach the keypad before you attach the front cover.
If you did not move Jumper S5, attach the front cover.
Make sure that you do not pinch wires or signal lines between the front cover and the drive before you
reattach the cover.
◆

Switches and Jumpers on the Terminal Board

The terminal board has switches to adapt the drive I/Os to the external control signals as shown in
Set the switches to select the functions for each terminal.
Posi
Switch
tion
A Jumper switch S5
DIP switch S1
B
DIP Switch S2
88
(G) of the drive.
Figure 3.39 Prepare the Ends of Shielded Wire
Figure 3.40 Reattach the Front Cover
Figure 3.41 Locations of Switches
Table 3.14 I/O Terminals and Switches Functions
Terminal
AM Sets the Output method for terminal AM (voltage or current).
A2 Sets the input method for terminal A2 (voltage or current).
Enables and disables the MEMOBUS/Modbus communications
-
termination resistor.
C - Insulate with electrical tape or
shrink tubing.
Function
YASKAWA SIEPC71061753A GA500 Technical Manual
Figure 3.41.
Default
V (voltage output)
I (current input)
OFF