Stapler Door Assembly - Xerox DocuColor 12/DCCS50 Service Manual

REP 15.3.1 Finisher
Parts List on PL 18.4
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Move the Finisher away from the printer.
3. Disconnect the Finisher (Figure 1).
1. Remove the thumb screw from the end of the Docking Rail Assembly, and pull the
Finisher free from the Docking Rail Assembly.
2. Disconnect the Finisher IOT Connector from the rear of the printer.
3. Roll the Finisher away from the printer.
Replacement
1. Move the Finisher to within 12 inches (304.8 mm) of the printer.
2. Reinstall the Docking Rail Assembly under the printer.
3. Secure the Docking Rail Assembly with the thumb screw.
4. Reconnect the Finisher IOT Connector to the printer.
5. Push the Finisher in against the printer, making sure that the Docking pin on the printer is
aligned with the Docking Plate locating hole on the Finisher.
Figure 1 Disconnect the Finisher
Reissue
DocuColor 12/DCCS50
WARNING
REP 15.3.2 Stapler Door Assembly
Parts List on PL 18.2
Removal
To avoid personal injury or shock, disconnect the Finisher cable connector. Switch off
the machine power and disconnect the machine Power Cord.
1. Switch off the printer power and disconnect the AC Power Cord.
2. Remove the Stapler Door Assembly
1. Open the Stapler Door.
2. Remove the C-Clip securing the top hinge.
3. Lift and remove the Stapler Door.
Replacement
1. Reinstall the Stapler Door in the reverse order of removal.
Figure 1 Remove the Stapler Door Assembly
1/05
8d-111
WARNING
(Figure 1).
Finisher/Sorter
REP 15.3.1, REP 15.3.2