Table of Contents
Advertisement
If the actuator is OK, go to
Flag 8
and
Flag 9
intermittent short circuit. If the wires are good, replace the Stacker Paper Sensor
Finisher/Sorter
12-531, 12-536
on BSD 12.15. Check for a loose connection or an
(PL
12-536 RAP
18.27).
The Staple Cartridge Set Switch does not detect the presence of a Staple Cartridge.
Initial Actions
Refer to BSD 12.13 for this procedure.
Check the following:
•
A loaded Staple Cartridge is installed in the Stapler.
•
Connectors
P/J1044
rectly, and there are no obvious crimped or broken wires.
Procedure
Enter dC330 012-274 Cartridge Set Switch. Press Start. The display is Low.
Y
N
There is less than 1 VDC from P/J1044-8 to GND.
Y
N
Go to
Flag 1
on BSD 12.13. Check for an open circuit. If the wire is good, replace the
Stapler Assembly
Replace the Finisher PWB
The problem may be intermittent. Go to
the wire is good, Check for damage to the Staple Cartridge. if the problem persists, replace the
Stapler Assembly
(PL
18.17).
1/05
8d-54
manuals4you.com
manuals4you.com
on the Finisher PWB and
P/J1092
on the Stapler are seated cor-
(PL
18.17).
(PL
18.4).
Flag 1
on BSD 12.13. Check for a loose connection. If
Reissue
DocuColor 12/DCCS50
Advertisement
Table of Contents
Troubleshooting
