Cisco 300 Series Cli Manual page 451

22
451
•
mask
—Specifies the network mask of the IP address.
•
prefix-length
—Specifies the number of bits that comprise the IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range:
8–30)
•
default-gateway-ip-address
The route is gotten a metric of 1.
Default Configuration
No IP address is defined for interfaces.
Command Mode
Interface Configuration mode
User Guidelines
Use the ip address command to define a static IP address on an interface.
In router mode.
Multiple IP addresses are supported. A new defined IP address is added on the
interface.
Defining a static IP address on an interface stops a DHCP client running on the
interface and removes the IP address assigned by the DHCP client.
If a configured IP address overlaps another configured one a warning message is
displayed. To change an existed IP address, delete the existed one and add the
new one.
In switch mode.
One IP address is supported. A new defined IP address overrides the previously
defined IP address.
Defining a static IP address stops a running DHCP client and deletes the IP
address assigned by the DHCP client.
While no IP address is assigned either by DHCP client or manually the default IP
address 192.168.1.254 is assigned on the Default VLAN.
Examples
Example 1. The following example configures VLAN 1 with IP address
131.108.1.27 and subnet mask 255.255.255.0.
—Specifies the default gateway IP address.
OL-32830-01 Command Line Interface Reference Guide
IP Addressing Commands