Cisco 300 Series Cli Manual page 423

19
423
Syntax
show green-ethernet [
Parameters
•
interface-id—(Optional) Specifies an Ethernet port
•
detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display for all ports. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
User Guidelines
The power savings displayed is relevant to the power saved by:
•
Port LEDs
•
Energy detect
•
Short reach
The EEE power saving is dynamic by nature since it is based on port utilization and
is therefore not taken into consideration.
The following describes the reasons for non-operation displayed by this
command.
If there are a several reasons, then only the highest priority reason is displayed.
Energy-Detect Non-Operational Reasons
Priority Reason
1 NP
2 LT
3 LU
interface-id | detailed
Description
Port is not present
Link Type is not supported (fiber, auto
media select)
Port Link is up – NA
OL-32830-01 Command Line Interface Reference Guide
]
Green Ethernet