Logging Aggregation Aging-Time; Logging Origin-Id - Cisco 300 Series Cli Manual

49
SYSLOG Commands

49.13 logging aggregation aging-time

To configure the aging time of the aggregated SYSLOG messages, use the
logging aggregation aging-time Global Configuration mode command. The
SYSLOG messages are aggregated during the time interval set by the aging-time
parameter. To return to the default, use the no form of this command.
Syntax
sec
logging aggregation aging-time
no logging aggregation aging-time
Parameters
sec
aging-time —Aging time in seconds (Range: 15–3600)
Default Configuration
300 seconds.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#
logging aggregation aging-time 300

49.14 logging origin-id

To configure the origin field of the SYSLOG message packet headers sent to the
SYSLOG server, use the logging origin-id Global Configuration mode command.
To return to the default, use the no form of this command.
Syntax
hostname IP IPv6 string user-defined-id
logging origin-id { | | | }
no logging origin-id
965 OL-32830-01 Command Line Interface Reference Guide