Dot1X Timeout Quiet-Period - Cisco 300 Series Cli Manual

802. 1 X Commands
OL-32830-01 Command Line Interface Reference Guide
Syntax
dot1x system-auth-control
no dot1x system-auth-control
Parameters
N/A
Default Configuration
Disabled.
Command Mode
Global Configuration mode
Example
The following example enables 802.1X globally.
switchxxxxxx(config)#

2.20 dot1x timeout quiet-period

Use the dot1x timeout quiet-period Interface Configuration mode command to set
the time interval that the device remains in a quiet state following a failed
authentication exchange (for example, if the client provided an invalid password).
Use the no form of this command to restore the default configuration.
Syntax
dot1x timeout quiet-period
no dot1x timeout quiet-period
Parameters
•
seconds
—Specifies the time interval in seconds that the device remains in
a quiet state following a failed authentication exchange with a client. (Range:
10–65535 seconds).
dot1x system-auth-control
seconds
2
66