Snmp-Server Source-Interface-Ipv6 - Cisco 300 Series Cli Manual

45
863
Use the no snmp-server source-interface informs command to remove the source
interface for SNMP informs.
Use the no snmp-server source-interface command to remove the source
interface for SNMP traps and informs.
Example
The following example configures the VLAN 10 as the source interface for traps.
switchxxxxxx(config)#

45.5 snmp-server source-interface-ipv6

To specify the interface from which a Simple Network Management Protocol
(SNMP) trap originates the informs or traps, use the snmp-server source-interface
command in Global Configuration mode. To returned to the default, use the no form
of this command.
Syntax
snmp-server source-interface-ipv6 {traps | informs}
no snmp-server source-interface-ipv6 [traps | informs]
Parameters
•
traps—Specifies the SNMP traps interface.
•
informs—Specifies the SNMP traps informs.
•
interface-id—Specifies the source interface.
Default Configuration
The IPv6 source address is the IPv6 address of the outgoing interface and
selected in accordance with RFC6724.
If no parameters are specified in no snmp-server source-interface, the default is
both traps and informs.
Command Mode
Global Configuration mode
Network Management Protocol (SNMP) Commands
snmp-server source-interface traps vlan 100
OL-32830-01 Command Line Interface Reference Guide
interface-id