Cisco 300 Series Cli Manual page 627

27
627
•
—Maximum transmission unit of the interface.
•
ICMP error messages—Specifies the minimum interval (in milliseconds)
between error messages sent on this interface.
•
number of DAD attempts:—Number of consecutive neighbor solicitation
messages that are sent on the interface while duplicate address detection
is performed.
•
ND reachable time—Displays the neighbor discovery reachable time (in
milliseconds) assigned to this interface.
•
MLD Version—The version of MLD
•
Tunnel mode—Specifies the tunnel mode: manual, 6to4, auto-tunnel or
isatap
•
Tunnel Local IPv4 address—Specifies the tunnel local IPv4 address and
have one of the following formats:
-
ipv4-address
-
ipv4-address
-
ipv4-address
•
Tunnel Remote Ipv4 address—Specifies the tunnel remote IPv4 address
•
ISATAP Router DNS name is—The DNS name of the ISATAP Router
Example 4. The following command with the brief keyword displays information
about all interfaces that IPv6 is defined on:
switchxxxxxx#
show ipv6 interface brief
Interface Interface
State
--------- --------- -------
vlan 1 up/up
vlan 2 up/up
vlan 3 up/down
vlan 4 down/down enabled
vlan 5 up/up
(auto)
interface-id
( )
IPv6 Link Local
State IPv6 Address
----------------- -------
FE80::0DB8:12AB:FA01
enabled
stalled FE80::0DB8:12AB:FA01
FE80::0DB8:12AB:FA01
enabled
FE80::0DB8:12AB:FA01
enabled FE80::0DB8:12AB:FA01
OL-32830-01 Command Line Interface Reference Guide
IPv6 Commands
MLD Number of
Version Global Addresses
----------------
1 1
1 1
1 3
2 2
1 1